Tongue and groove pine porch flooring is installed in a similar manner to the interior hardwood floors, with boards that are nailed and held together at the sides with tongue and groove fittings. However, covered porch is much longer, so you can put your hand on the board for a course, instead of joining the pieces to short boards. Allow the boards to acclimate to the local environment for at least a week before installation.
Ideas for replace tongue and groove pine porch flooring, remove all the old cover from the joists, using your hammer. Pull all remaining nails out of the joists. Extend the platform tables on the floor, face down. Paint the back and sides of the joints with a thin layer of primer-sealed moisture. Let the primer dry for a day. Measure the length of the gantry, perpendicular to the direction of the joists. Cut the first board on which the length of the miter saw.
Set the first plate in place next to a porch edge, with the grooved side facing the house. Leave a 3/8 inch space on the wall. Fix the plate in place by shooting pairs of nails across the surface at each point where it intersects with a joist. Then for replace tongue and groove pine porch flooring, measure and cut the second board. Set in place next to the first, connecting them by the tongue and groove edges. Use a piece of scrap metal and cover your hammer to hit the plate firmly against the first one. Nail it on the side instead of the top, shoot a nail at an angle at each junction with a beam.